Filter
Top Products
16
Playing a CD
1. Turning On the System. Press SYSTEM POWER on the DR-3
remote to turn on the Digital Solution system. Press the DVD
Source/Device button and then press the SOURCE POWER button
(bottom, top, bottom). The CD/DVD player will turn on and the
power indicator light will turn green. After a few seconds delay,
a cheery “HELLO” appears in the display of the DVD player.
You can make the turn-on procedure a lot simpler by setting up a
“Macro.” The DR-3 remote can be programmed to turn on all of the
audio and video components in your system with one button push.
See page 12 of the DR-3 Owner’s Manual for instructions on how
to set up a Macro.
2. Opening Disc Drawer. Press the OPEN button on the front panel
of the CD/DVD player. Or, press ^ TV/VCR on the DR-3 remote. The
disc tray opens. You can open the disc tray by pressing this button
even if the CD/DVD player is in standby mode (off).
3. Inserting CD. Place a disc on the disc tray with the playback side
down. Place the disc in the guide on the disc tray. If the disc is out
of the guide, it may damage the disc and cause the DVD player to
malfunction. Do not place anything except 3" discs or 5" discs on
the disc tray.
4. Starting Play. Press ENTER/PLAY. The disc tray closes
automatically and playback begins. If the disc is upside down
“NO DISC” or “DISC ERROR” appears on the TV screen. Flip it.
5. Setting Volume. Use the VOL buttons to set volume
to taste using the DR-3.
6. Setting Bass Level. Use the SUB+ and SUB- buttons to set bass
level to taste using the DR-3.
7. Choosing Surround Mode. If you want to hear a stereo CD in
surround sound, press the SURROUND button to 5 Channel
Surround (surround sound with all speakers playing).
8. Pausing the CD. To temporarily suspend play, press the PAUSE
button. Press the ENTER/PLAY button to resume playing.
9. Listen to music.
10. Relax or dance.
11. Press STOP to stop the playback.
12. The DP-1 CD/DVD player will automatically shut off if left idle
for 10 minutes.
Advanced CD Operation
13. Selecting Tracks. If you want to skip to a different track on a CD,
press the button to move forward, or the button to move
back track by track in the disc. You may also use the numeric keys
to go directly to a track. To get to tracks higher than 9, use a two
button press combination. For example, if you want to listen to
track 10, press 1 followed by the 0. To hear track (or chapter) 12,
press 1 followed by the 2. You have about two seconds between key
presses before the DR-3 accepts the digit. Press two-key combos in
quick succession, or the DR-3 will only recognize the first number keyed.
14. Scan Forward/Scan Reverse. To move forward or backward
at higher than normal speed, use the FF > and < REW buttons.
Each time you press the button the playing or reversing speed
increases. Press the PLAY button to resume normal playing
speed and direction.
15. Audio. This button changes what part of the audio signal you are
listening to (i.e. left channel only, right channel only, or the full stereo
signal). Set it so that “STER” appears onscreen and leave it alone.
CD OPERATION
5
13
14
4
2
6
7
8
15
12
1
www.polkaudio.com