Polk Audio DP-1 DVD Player User Manual


 
www.polkaudio.com
11
Erasing All the Learned Commands
in All Device Modes
This procedure will erase all the learned commands on all the buttons
in all eight Source/Device modes. Be really, really sure you want to do
this before following the steps below.
1. Press and hold the LEARN button for two seconds.
The Status light at the top left of the remote will glow orange.
2. Press and hold the LEARN button again for 10 seconds. The
Status light will flash red continuously. The status light will then
flash green once, orange once then turn off, indicating that all of
the learned commands in all of the Source/Device modes on the
remote control have been erased.
Restoring Factory Programming
If you want to restore the DR-3 to it’s original programming and oper-
ation, press the LIGHT and POWER buttons simultaneously for 10
seconds. The red status light will blink while the remote is resetting.
It will confirm the reset by blinking green and then orange.
PROGRAMMING THE REMOTE
1
,2