Filter
Top Products
27
Preparation
long as it has been set up as a television, VCR, cable
box, or satellite receiver).
Important:
If you program Favorite Channel Scan, you
can no longer use
SCAN
for Channel Scan (see “Using
Channel Scan” on Page 37). If you want to use the re-
mote for Channel Scan after you have programmed it for
Favorite Channel Scan, you must reset the entire opera-
tion of the remote (see “Using Operation Reset” on
Page 44). You lose all stored information.
Note:
If no key is pressed for 60 seconds, the remote
control automatically exits setup.
;N?J?D=
;N?J?D=;N?J?D=
;N?J?D=
appears, and
the remote returns to the previous mode screen.
Follow these steps to program Favorite Channel Scan.
1. Hold down
P
for at least 3 seconds.
9E:;ý I;J
9E:;ý I;J9E:;ý I;J
9E:;ý I;J
appears.
Note:
To exit setup, hold down
P
again for at least 3
seconds.
;N?J?D=
;N?J?D=;N?J?D=
;N?J?D=
appears, then the last-used mode
screen.
2. Touch the up arrow twice.
<7Lý9>7D
<7Lý9>7D<7Lý9>7D
<7Lý9>7D
appears.
Note:
If you scroll past
<7Lý9>7D
<7Lý9>7D<7Lý9>7D
<7Lý9>7D
, touch the down
arrow to return to it.
3. Touch
SELECT
. The last selected mode appears.
4. Touch a device key (
TV
,
VCR/DVD
,
CAB/SAT
,
AUX 1
,
AUX 2
,
AUX 3
, or
AUX 4
). The selected mode
appears.
5. Touch
SELECT
.
;DJý9>7D
;DJý9>7D;DJý9>7D
;DJý9>7D
appears.
6. Enter a favorite channel by touching the corre-
sponding numbers on the keypad. To accept the
entry, touch
SELECT
.
;DJý9>7D
;DJý9>7D;DJý9>7D
;DJý9>7D
appears.
Note:
A channel number can be up to four digits (for
example, 2, 13, 132, or 1024).
7. Repeat Step 6 up to nine more times to enter other
favorite channels for the same device.