Filter
Top Products
40
Operation
3. Touch
SELECT
.
7BBýCE:;
7BBýCE:;7BBýCE:;
7BBýCE:;
appears.
4.
To unlock all modes
, touch
SELECT
.
KDBE9A;:
KDBE9A;:KDBE9A;:
KDBE9A;:
appears, then
;N?J?D=
;N?J?D=;N?J?D=
;N?J?D=
, then the last-used mode
screen.
To unlock individual modes
, touch the up or down
arrow.
ED;ýCE:;
ED;ýCE:;ED;ýCE:;
ED;ýCE:;
appears. Press
SELECT
.
I;Bý CE:;
I;Bý CE:;I;Bý CE:;
I;Bý CE:;
appears. Touch a mode (for example,
TV
) where
you want the volume controls to be unlocked.
KDBE9A;:
KDBE9A;:KDBE9A;:
KDBE9A;:
appears, then
I;BýCE:;
I;BýCE:;I;BýCE:;
I;BýCE:;
.
Note:
If the mode is already unlocked, an error
beep sounds and
?DL7B?:
?DL7B?:?DL7B?:
?DL7B?:
appears.
To unlock another mode
, repeat Step 4 as often as
needed.
5. To exit the program, hold down
P
until
;N?J?D=
;N?J?D=;N?J?D=
;N?J?D=
appears. The last-used mode screen appears.
USING LEARNING
Your remote control is equipped with a learning program
so you can add a function unique to a home entertain-
ment device (for example, tracking up or down for a
VCR). You can skip this section if you are satisfied with
the remote control operation on all devices.
Learning a Function
This method assumes all devices have been set up. If
not, perform the instructions in “Setting Up The Remote”
on Page 23. Also, have your original remote controls
handy before programming learning.
Follow these steps to learn a function.
1. Select the mode key for the desired learning mode.
2. Hold down
P
for at least 3 seconds.
9E:;ý I;J
9E:;ý I;J9E:;ý I;J
9E:;ý I;J
appears.
Note:
To exit setup, hold down
P
for at least 3 sec-
onds.
;N?J?D=
;N?J?D=;N?J?D=
;N?J?D=
appears, then the last-used mode
screen.