Filter
Top Products
O
WNER
’
S
M
ANUAL
USING MACROS
The RadioShack 8-in-One Remote includes six macro keys: M1 through
M4,COM MUTE,and PWR.Each one can be set up to perform a repetitive,
time-consuming operation with the press of a single key.
NOTES:A macro programmed onto the PWR key can only be accessed in the MY
SYSTEM mode.Pressing it in any other mode will only send a “Power On/Off”
IR command to the selected device.The COM MUTE key can be programmed as a
two-state rotating macro.See “Programming The COM MUTE Key”on page 27.
A macro can be used to control a home theater operation,to set a
favorite channel,or for other multiple functions you would like to control
with one key press.Moreover,each macro key can hold up to 15 key
presses total.
NOTE: Programming a new macro over an existing one will erase the
original macro.
PROGRAMMING A FAVORITE CHANNEL MACRO
With so many channels available on your cable or satellite system,you
can program a macro that directly selects a favorite channel with one
key press.For example,let’s assume your favorite cable programs are
on channel 71.Use the following instructions to program a macro for
direct access of this channel:
NOTE: The following example assumes all equipment is turned off and that the
TV is connected through the Cable Box with TV tuning set to channel 3.
1. Press and hold Puntil the bottom IR segment flashes twice.
The program keys will appear:
2. Press above MACRO once.The Macro programming screen will appear:
3. Press an open macro key (e.g.,M1,M2,M3,or M4).The last-selected
device menu screen,including , will be displayed.
4. Enter a desired macro sequence of up to 15 key presses.For this
example,press TV once,followed by PWR once, and then enter 0 3 for
the TV’s channel number.Next,press CBL once,followed by PWR
once, and then enter 0 7 1 for the Cable Box’s channel number.
continued on next page...
Using Macros 25
RS 8in1 Kameleon OM rev 10/9/03 4:11 PM Page 25