Filter
Top Products
O
WNER
’
S
M
ANUAL
6. Exit programming by pressing once.The display will return to the
last-selected device menu screen.
7. To test the power macro,first make sure all home theater devices
selected in step 4 are turned on.Aim the remote control at the
devices and press MY SYSTEM once,followed by PWR once. The
devices should turn off in this order: Satellite Receiver,DVD Player,
Audio Receiver,and TV.
To turn on the devices on again in the same order as above,press
PWR once.
PROGRAMMING THE COM MUTE KEY
If desired,a two-state rotating macro can be programmed onto the COM
MUTE key,so a key press will drop volume (in the CBL,SAT,TV, VCR,or
AUX mode) to a preset level during a commercial.When the program
resumes,another key press will raise it back to the original level.
1. Press and hold Puntil the bottom IR segment flashes twice.
The program keys will appear:
2. Press above MACRO once.The Macro programming screen will appear:
3. Press COM MUTE once.The last-selected device menu screen,including
,will be displayed.
4. Enter the first macro sequence by pressing TV once,then press VOL▼
four times (to lower the volume four steps).
5. To save the macro,press and hold P until the bottom IR segment
flashes twice.The program keys will appear again.
6. To program the second macro,repeat steps 2 through 5,but substitute
VOL ▲for VOL▼this time (to raise the level four steps).
7. Exit programming by pressing once.The display will return to the
last-selected device menu screen.
continued on next page...
Using Macros 27
RS 8in1 Kameleon OM rev 10/9/03 4:11 PM Page 27