Filter
Top Products
8-
IN
-O
NE
R
EMOTE
P
OWERED
B
Y
K
AMELEON
INSTALLING BATTERIES
ABOUT THE FINDER TRANSMITTER (CONTINUED)
INSTALLING A BATTERY IN THE FINDER TRANSMITTER
1. Press down on the battery compartment cover (on the front of the
Finder Transmitter) and slide it off.
2. Locate the snap harness and connect the 9-volt battery to mating
terminals.Then insert the battery and harness into the compartment.
3. Align the cover with the compartment opening and slide it back
into place.
OPERATING THE FINDER TRANSMITTER
1. Point the Finder Transmitter in the general direction of the lost
RadioShack 8-in-One Remote.
2. Press and hold the Finder Transmitter’s button until the lost RadioShack
8-in-One Remote emits a chirping sound to help you find it.
NOTE: If the RadioShack 8-in-One Remote does not emit a chirping sound,
verify the Finder Receiver is enabled (see page 39) and the battery is fresh.
A QUICK LOOK AT THE CONTROLS
Use the illustration on the next page to locate controls and then study
the Key Functions to learn how they function.
NOTE: The illustration shows all remote control keys.In actual operation,only
active keys used by the selected device are displayed and non-active keys are
hidden.These controls work like the ones found on your original remote controls.
To find out what type of devices can be controlled by each device key
after programming,see the Device Table on page 12.
6 Installing Batteries/A Quick Look At The Controls
❶
❸
❷
RS 8in1 Kameleon OM rev 10/9/03 4:11 PM Page 6