Filter
Top Products
Connections & Setup
16 Chapter 1
Tip
To access the setup menus manually, press
MENU and choose SETUP.
English
Français
Español
Welcome Screen and Connection Confirmation
The next screen welcomes you to your new RCA TV. Press OK to continue with
the setup. After the welcome screen, the initial setup asks you to make sure
that you've connected the HDTV to your cable or antenna signal. Once you've
conrmed that the HDTV is connected, press OK. The Channel setup screen
appears.
Sit back, relax and enjoy the vivid
colors, realistic pictures, and
surround sound of your new RCA TV.
Press OK to continue
Channel setup
Go back
Signal Source
Analog Signal type
Auto channel search
List and labels
Both...
Cable...
Start
...
Press < / > to select where you would like to
search for channels.
Complete the Initial Setup
The menu system in your TV allows the TV’s features to work properly. The
rst time you turn on your TV, the setup screens appear.
Set the Menu Language
The rst part of the setup allows you to select your preferred language for the
menu system.
If English is your preferred language, press OK. If you want to choose another
language, press the down arrow button until that language is highlighted, and
press OK.
Complete the Auto Channel Search
The Channel setup screen lets you set your signal source and search for the
available channels on that source. The Auto channel search allows the TV to
search for all the viewable channels on both of your tuners—for digital or
analog channels—or on each antenna separately. This is sometimes called auto
programming.
When you rst turn on your HDTV, it's set to search on both tuners.
To search for channels on the both tuners:
1. Make sure the Signal Source is set to Both. If it's not, use the right arrow to
change the setting to Both.
2. Press the down arrow button on your remote control to highlight Analog
Signal Type.
3. Use the right arrow button to choose the signal type you're receiving on the
analog tuner—either UHF/VHF Antenna for an off-air antenna or Cable.
4. Press the down arrow button on your remote control to highlight Auto
channel search.
5. Press OK to start the Auto channel search on both tuners.
When the channel search is complete, press OK to access the List & Labels
screen.
Note: The Auto Channel Search looks for channels for the Signal Source
you choose—analog, digital, or both. To perform the Auto Channel
Search for just one tuner, choose that tuner in step 1 above. Then follow
the rest of the steps.