Filter
Top Products
24 Chapter 2
Using the Remote Control
Find Out If You Need to Program the Remote
To determine whether the universal remote needs to be programmed to
operate one of the devices connected to your TV, such as a DVD player, do the
following:
1. Turn on the device (in this example, a DVD player).
2. Point the remote at the device.
3. Press the corresponding device button (in this example, DVD).
4. Press ON•OFF to see if the DVD player responds. If the DVD player
doesn’t respond, you need to program the remote to operate it.
Programming the Remote
There are three ways to program the remote control to operate other devices:
Direct Entry, Manual Code Search and Automatic Code Search. If you have
recently purchased the device you want to control or if the device has many
codes, you might want to try the manual code search rst. The codes in the
code list at the end of this chapter are programmable for any of these device
buttons (SAT•CABLE, AUX or DVD) on the TV's remote.
Using Direct Entry
1. Turn on the device you want to control.
2. Look up the brand and code number(s) for the device on the code list at
the end of this section.
3. On your remote control, simultaneously press and hold the ON•OFF and
MUTE buttons (approximately 3 seconds) until a device button remains lit.
Then release the buttons.
4. Press and release the device button (SAT•CABLE, AUX or DVD) you want
to program.
5. Enter a three digit code from the code list.
6. To test the code you’ve programmed for that device button, point the
remote at the device and then press ON•OFF to see if the device responds
to the remote control.
If the device turns off, you’ve entered the correct programming code for your
device. (You might want to circle the code for future reference). If the device
doesn’t turn off, repeat these steps until you’ve tested all codes for your device’s
brand or try to run a manual code search.
Using Manual Code Search
Note: Try the direct entry method first, or if you want the AUX button to
operate your DVR, for example, enter the first code from the DVR code
list. (You save time by telling the remote what type of device you want to
program). Now proceed with the following steps.
1. Turn on the device you want to control.
2. On your remote control, simultaneously press and hold the ON•OFF and
MUTE buttons (approximately 3 seconds) until a device button remains lit.
Then release the buttons.
You’ll use these buttons for Direct
Entry.
Important: The remote may not
be compatible with all models of
all brands of devices. It also may
not operate all functions of your
device.
INPUT
ANT•CABLE
REVERSE
PLAY
FORWARD
STOP
PAUSE
RECORD
MENU
CLEAR
FORMAT
SUB
CH
INFOGUIDE
MUTE
GO BACK
VOL
CH
ON•OFF
SAT•CABLE
AUX
DVD
TV