RCA RCU800B Universal Remote User Manual


 
22
RCU403
(OFF)
123
456
789
0
ON•OFF
TV CODE
Program for TV—Direct Entry Method
1. Manually turn on the TV.
2. Locate the enclosed TV Code List. Find your brand of TV.
Note: If your brand isn’t listed, use one of the Code Search methods to
program this remote control (See Code Search on page 24).
3. Press and hold the CODE SEARCH key until the indicator light
illuminates. Then release the CODE SEARCH key.
4. Press and release the TV key. The indicator light blinks and then remains lit.
5. Use the number keys to enter the first code listed for your brand.
After you enter a valid three-digit code, the indicator light turns off.
Note: If you enter an invalid code, the LED will flash rapidly for 2 seconds.
Start over at step 3.
6. Aim the remote at your TV and press the ON•OFF key. If your TV turns off,
you have found the correct code.
7. Enter the code in the box provided on this page for future reference.
8. If your TV doesn’t turn off, repeat steps 3-6 above, entering the next code
for your brand.
If none of the codes work or your brand is not listed, use one of the Code
Search methods to program this remote (See Code Search on page 24).
For a description of each key on the remote control, refer to the Key
Descriptions section on page 21.
In order for the 3 component universal remote to control your TV, you must program it with the TV code
that matches your TV. These instructions explain the preferred method of programming the remote—the
Direct Entry method.
CODE
SEARCH
INDICATOR
LIGHT
(BLINK)
TV
Program for DVD or VCR—Direct Entry Method
VCR•
DVD
1. Manually turn on the VCR or DVD player.
2. Locate the enclosed VCR or DVD Code List. Find your brand in the VCR
Codes or DVD Codes section, respectively.
Note: If your brand isn’t listed, use one of the Code Search methods to program
this remote control
(See Code Search on page 24).
3. Press and hold the CODE SEARCH key until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the VCR•DVD key. The indicator light blinks and then
remains lit.
5. Use the number keys on the remote to enter the first code listed for your brand.
After you enter a valid three-digit code, the indicator light turns off.
Note: If you enter an invalid code, the LED will flash rapidly for 2 seconds.
Start over at step 3.
6. Aim the remote at the component (VCR or DVD player). Press the ON•OFF
key. If your VCR or DVD player turns off, you have found the correct code.
7. Enter the code in the box provided on this page for future reference.
8. If your VCR or DVD player doesn’t turn off, repeat steps 3-6 above, entering
the next code for your brand.
If none of the codes work or your brand is not listed, use one of the Code
Search methods to program this remote (See Code Search on page 24).
For a description of each key on the remote control, refer to the Key
Descriptions section on page 21.
In order for the 3 component universal remote to control your DVD or VCR, you must program it with the
code that matches your component. The VCR•DVD key can be programmed to operate either
a DVD or a
VCR player. These instructions explain the preferred method of programming the remote—the Direct Entry
method.
ON•OFF
(BLINK)
(OFF)
123
456
789
0
CODE
SEARCH
INDICATOR
LIGHT
VCR OR DVD CODE
RCU800B_IB_REVB.qx4 2/11/04 13:05 Page 22