Filter
Top Products
6
RCU800
Program for VCR1 and VCR2—Direct Entry Method
1. Manually turn on the VCR.
2. Locate the enclosed VCR Code List. Find your brand
in the VCR Codes.
Note: If your brand isn’t listed, use one of the Code Search
methods to program this remote control. (See section on
Code Search on page 11).
3. Press and hold the CODE SEARCH key until the indicator
light illuminates. Then release the CODE SEARCH key.
4. Press and release the VCR1 or VCR2 key. The indicator light
blinks and then remains lit.
5. Use the number keys on the remote to enter the first code
listed for your brand. After you enter a valid three-digit code,
the indicator light turns off.
Note: If you enter an invalid code, the LED flashes rapidly
for two seconds. Start over at step 3.
6. Aim the remote at your VCR. Press the ON•OFF key.
If your VCR turns off, you have found the correct code.
7. Enter the code in the box provided on this page for
future reference.
8. If your VCR does not turn off, repeat steps 3-6 above,
entering the next code for your brand.
If none of the codes work or your brand is not listed, use
one of the Code Search methods to program this remote.
(See Code Search section on page 11).
In order for the eight-component universal remote to control your VCR, you must program it with
the code that matches your VCR. If you have two VCR's, the second VCR can be programmed using
the VCR2 key. To program your remote to control your VCR, follow these steps:
(BLINK)
VCR1 CODE
(OFF)
1. Manually turn on the DVD/CD system.
2. Locate the enclosed DVD or CD Code List.
Find your brand in the DVD or CD Codes.
Note: If your brand isn’t listed, use one of the
Code Search methods to program this remote control.
(See section on Code Search on page 11).
3. Press and hold the CODE SEARCH key until the indicator
light illuminates. Then release the CODE SEARCH key.
4. Press and release the DVD key. The indicator light blinks
and then remains lit.
5. Use the number keys on the remote to enter the first code
listed for your brand. After you enter a valid three-digit
code, the indicator light turns off.
Note: If you enter an invalid code, the LED flashes rapidly
for two seconds. Start over at step 3.
In order for the eight-component universal remote to control your DVD or CD systems, you must
program it with the code that matches your component. To program your remote to control your
DVD/CD system, follow these steps:
(BLINK)
Program for DVD/CD Systems—Direct Entry Method
CODE
SEARCH
INDICATOR
LIGHT
CODE
SEARCH
INDICATOR
LIGHT
(OFF)
ON•OFF
VCR1
DVD
VCR2
VCR2 CODE
RCU800B_IB_REVB.qx4 2/11/04 13:05 Page 6