Filter
Top Products
3
RCU800
Congratulations on your purchase of the eight-component universal remote. This universal remote
controls up to eight electronic components and makes juggling remote controls a thing of the past.
You can program this RCA universal remote to operate most models of most brands of infrared,
remote-controlled components manufactured after 1990. (See enclosed Code List for a complete list
of brands.) The eight-component universal remote is easy to use, easy to program and gives you
control at the touch of your fingertips.
Note: The eight-component universal remote is already programmed to operate most RCA, GE
and PROSCAN branded TVs, VCRs, DVD players and SATELLITE receivers (DBS). Just press
the corresponding component key—TV, VCR1, VCR2, DVD, DBS•SAT, CABLE, AUDIO, AUX—
and your eight-component universal remote is ready to go!
Indicator Light—flashes when a valid key is pressed to indicate
the remote is working. Status of this light is important when
you are programming the remote.
Component Keys (TV, VCR1, VCR2, DVD, DBS•SAT, CABLE, AUDIO,
AUX)— selects the component you want the remote to operate.
For example, after you’ve programmed the remote to operate
your TV, you must press the TV key first to put the remote in
TV Mode. While in TV Mode, the CHAN keys change the channel
on the TV, the VOL keys adjust the TV’s volume, etc.
Transport Keys—REVERSE, PLAY, FORWARD, STOP, PAUSE,
RECORD—operate the same as your original VCR or DVD remote
control, although key labels may vary (REWIND, FAST
FORWARD).
Backlight Key (select models only)—turns backlighting on and off.
Backlighting remains on for approximately eight seconds after the
last keypress to conserve battery life.
Your universal remote requires two new AA alkaline batteries (batteries may
or may not be included, depending on the model). To install the batteries:
Battery Information and Installation
8 Component
Universal Remote
Key Descriptions
1. Remove the battery compartment cover.
2. Insert the batteries, matching the batteries to
the (+) and (-) marks inside the battery case.
3. Replace the battery cover.
Note: Reprogramming may be required after
batteries are replaced.
RCU800B_IB_REVB.qx4 2/11/04 13:05 Page 3