Filter
Top Products
23
RCU403
Program for Satellite or Cable Box—Direct Entry Method
DBS•
CABLE
1. Manually turn on the satellite receiver or cable box.
2. Locate the enclosed Satellite or Cable Box Code List. Find your brand in the Satellite
Codes or Cable Box Codes section, respectively.
Note: If your brand isn’t listed, use one of the Code Search methods to program
this remote control (See Code Search on page 24).
3. Press and hold the CODE SEARCH key until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the DBS•CABLE key. The indicator light blinks and then
remains lit.
5. Use the number keys on the remote to enter the first code listed for your brand.
After you enter a valid three-digit code, the indicator light turns off.
Note: If you enter an invalid code, the LED will flash rapidly for 2 seconds.
Start over at step 3.
6. Aim the remote at your satellite receiver or cable box and press the ON•OFF
key. If your Satellite receiver or cable box turns off, you have found the
correct code.
7. Enter the code in the box provided on this page for future reference.
8. If your satellite receiver or cable box doesn’t turn off, repeat steps 3-6 above,
entering the next code for your brand.
If none of the codes work or your brand is not listed, use one of the Code
Search methods to program this remote (See Code Search on page 24).
For a description of each key on the remote control, refer to the Key
Descriptions section page 21.
In order for the 3 component universal remote to control your satellite or cable box, you must program it with
the code that matches your component. The DBS•CABLE key can be programmed to operate either
a
satellite receiver or
a cable box. These instructions explain the preferred method of programming the
remote—the Direct Entry method.
DBS (SATELLITE)
OR
CABLE BOX CODE
ON•OFF
(BLINK)
(OFF)
123
456
789
0
CODE
SEARCH
INDICATOR
LIGHT
RCU800B_IB_REVB.qx4 2/11/04 13:05 Page 23