Filter
Top Products
24
RCU403
Code Search Methods
Manual Code Search
1. Turn on the component you want the remote to operate.
2. Press and hold the CODE SEARCH key until the indicator
light illuminates. Then release the CODE SEARCH key.
3. Press and release the component key that corresponds to the
component you want the remote to operate (TV, VCR•DVD
or DBS•CABLE). The indicator light blinks once and then
remains lit.
4. Aim the remote at the component and press the ON•OFF key
continuously until the component turns off.
Important: Because there are so many codes, you may have
to press the ON•OFF key many times—possibly up to
200 times.
5. When the component turns off, press the ENTER key to store
the code.
6. Use Code Retrieval on the next page to identify the code for
your component for future reference.
If your component’s brand isn’t listed in the Code List or you have tried all of the codes for your brand and
the remote does not operate your component, use one of the Code Search methods below—Manual Code
Search or Auto Code Search. Both Code Search methods search all of the codes because your component’s
code may be listed under another brand in the code list.
Note: The Code Search method may take a long time because the remote searches all of the codes in its
memory for the code which operates your component. Therefore, if your brand is listed in the Code List,
use the Direct Entry method described on pages 22-23.
DBS•
CABLE
VCR•
DVD
TV
DBS•
CABLE
VCR•
DVD
TV
Auto Code Search
1. Turn on the component you want the remote to operate.
2. Press and hold the CODE SEARCH key until the indicator
light illuminates. Then release the CODE SEARCH key.
3. Press and release the component key that corresponds to the
component you want the remote to operate (TV, VCR•DVD
or DBS•CABLE). The indicator light blinks once
and then remains lit.
4. Aim the remote at the component and press the ON•OFF key
once
. The remote automatically sends every code for the
specified component one at a time, with a 3 second delay
between each code. Keep the remote aimed at the component
throughout the process.
5. As soon as the component turns off, you must press the
ENTER key immediately so the remote stores the correct code.
If you don’t press ENTER within 3 seconds, the remote will
send the next code in the list, and you will have to start over
from step 2.
6. Use Code Retrieval to identify the code for your component for
future reference.
INDICATOR
LIGHT
CODE
SEARCH
ON•OFF
(BLINK)
INDICATOR
LIGHT
CODE
SEARCH
ENTER
ENTER
ON•OFF
(BLINK)
RCU800B_IB_REVB.qx4 2/11/04 13:05 Page 24