RCA Satellite TV Antenna Satellite TV System User Manual


 
Mounting the Mast 19
Mounting the Mast on Brick or Poured Concrete
IMPORTANT Considerations
The wall anchors used must have a strength of at least 300
pounds of pull-out pressure. B4015 or equivalent double-
expansion anchors are recommended.
Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
Mounting the Mast on Brick or
Poured Concrete
4 double expansion anchors
4 machine screws
4
5
/16
" washers
Materials Needed
Tools Needed
Electric drill with
1/2" masonry bit
Bubble level
Screwdriver
Hammer
7/16" wrench
Pencil
DANGER
AVOID Power Lines!
When following these
instructions, take
extreme care to avoid
contact with overhead
power lines, electric
lights, and power
circuits. Contact with
power lines, electric
lights, or power circuits
may be fatal. It is
recommended that the
dish be located more
than 20 feet from
overhead power lines.
Mounting Instructions
1. Hold the mounting foot in position on the mounting surface.
2. If you are mounting on a vertical or sloped surface, use a level to
ensure that the center line is vertical.
level on center
line of template
Level
Not Level
Step 1: Hold the mounting
foot in position.
Step 2: Make sure the mounting
foot is level.
3. Mark the four outside holes on the mounting foot.
4. Remove the foot and drill four (4) 1/2" holes in the locations
you marked.