20 Mounting the Mast
Mounting the Mast on Brick or Poured Concrete
5. Insert four (4) double-expansion anchors.
6. Use a wrench to loosen the nuts on the mounting foot so you
have easier access to the mounting holes.
7. Hold the mounting foot over the holes so the top part of the mast
will rotate and point straight up.
No
Yes
Mounting the Mast on a Hollow
or Cinder Block Wall
Materials Needed
Tools Needed
• Electric drill
with 1/2"
masonry bit
• Bubble level
• Screwdriver
• 7/16" wrench
• Pencil
4
1
/4
" hollow wall
togglers
4 machine screws
4
5
/16
" washers
Step 7: Make sure that the top of the mast will point straight up.
IMPORTANT Considerations
• Do NOT mount the dish under an eave or overhang that may
block or partially shadow the dish.
8. Insert and tighten the machine screws.
9. Go on to the next section, “Final Installation,” to complete the
installation process.