RCA Satellite TV Antenna Satellite TV System User Manual


 
Mounting the Mast 21
Mounting the Mast on a Hollow or Cinder Block Wall
DANGER
AVOID Power Lines!
When following these
instructions, take
extreme care to avoid
contact with overhead
power lines, electric
lights, and power
circuits. Contact with
power lines, electric
lights, or power
circuits may be fatal. It
is recommended that
the dish be located
more than 20 feet from
overhead power lines.
Mounting Instructions
1. When installing togglers in cinder blocks, it is important to
position them in the core of the block. To position the foot on the
wall, measure 7-1/2" from one edge of the block and mark the
center of the block.
2. Center the mounting foot on the mark you made.
3. Level the center line of the mounting foot using a bubble level.
level on center
line of template
Level
Not Level
7
1
/2"
4. Mark the four outside corner holes.
5. Remove the mounting foot. Drill a 1/2" hole at the marked
locations.
6. Install the togglers:
a. Carefully fold one end of the metal channel along the plastic
straps. Hold the metal channel flat against the plastic straps
and slide it through the hole.
Wall
Metal channel
Fold in
Step 6a: Slide the metal channel through the hole.
b. Pull the ring so the metal channel rests flush behind the wall.
Hold the ring tight and slide the plastic cap along the straps
until the cap is flush with the wall.
Wall
Plastic cap
Ring
Metal
chann
Step 6b: Make sure the plastic cap is flush with the wall.