Filter
Top Products
English - 54
Playback
Skip
In Play mode, press F.ADV/SKIP button to cue ahead exactly 30
seconds. Press F.ADV/SKIP button repeatedly up to 4 times to cue ahead
2 minutes.
Slow motion
In Still mode, press ►► button for slow motion. Press the ►► button
repeatedly to play slow motion speed at 1/10, 1/7, 1/5 times. Press the
PLAY button twice to resume normal viewing.
S-VHS Playback
The DVD Recorder & VCR allows you to playback high quality S-VHS
tapes.
1. Insert an S-VHS tape into the VCR deck.
2. Press ►II (PLAY/STILL) button on the remote control or on the front
panel to play an S-VHS tape.
Variable Search System
Each time you record a cassette on this DVD Recorder & VCR, an
“index” is automatically marked on the tape when recording is
started. The Search function allows you to fast-forward or rewind to
a specifi c index and start playback from that point. Depending on
the direction selected, the indexes are numbered as follows
• This DVD Recorder & VCR uses a standard indexing system (VISS).
As a result, it will recognize any indexes marked by other VCRs using
the same system and vice versa.
Go To Zero
Use this feature when you want to search for the 0:00:00 counter
position on a cassette.
1. During playback, press the CANCEL button at the point on the tape
where you want to set the counter to 0:00:00.
2. While a cassette is stopped, press the ANYKEY button.
3. Press the ▲▼ buttons to select Go To Zero, then press the ENTER
button. The VCR will rewind or fast forward, searching for the 0:00:00
counter position, and then automatically stop at that position.
End Search
Use this feature when you want to search for a blank position to
record a program on a cassette.
1. While a cassette is stopped, press the ANYKEY button.
2. Press the ▲▼ buttons to select End Search, then press the ENTER
button. The VCR will fast forward, searching for a blank position, and
then automatically stop at that position. If the VCR reaches the end of
the tape during end search, the tape will be ejected.
Forward/Reverse Intro Scan
Use scan and play when you don’t know exactly where a program is
located on a cassette tape.
1. While a cassette is stopped, press the ANYKEY button.
2. Press the ▲▼ buttons to select Forward Intro Scan or Reverse Intro
Scan, then press the ENTER button. When an Index mark is found, the
DVD Recorder & VCR will playback the tape for 5 seconds, after which
it will continue searching for the next Index mark.
▌
▌
Scan and Play
►►
00:01:49
End Search
►►
00:00:13
Go To Zero
◄◄
00:00:49
01343A-VR355-XAC-ENG.indb 5401343A-VR355-XAC-ENG.indb 54 2007-03-23 오후 6:51:332007-03-23 오후 6:51:33