Filter
Top Products
Reference
English - 84
Troubleshooting (DVD)
Problem Explanation/Solution
icon appears on the
screen.
You cannot use the operation or function due to one of the following reasons:
(1) Your DVD disc does not support the feature (for example, angles)
(2) You've requested a title, chapter, or scan time that is out of the correct range.
Play mode settings
are different from the
settings confi gured
with the Setting menu.
The disc does not support all the selected functions.
In this case, some settings you confi gure on the Setting menu may not work properly.
Cannot change the
aspect ratio.
Aspect ratio is fi xed on DVD disc.
No audio output.
Check whether you selected the correct digital output options in the Audio Output Options
menu.
No video or audio
output.
The disc tray is ejected
after 2 to 5 seconds.
Did you move your DVD Recorder & VCR suddenly from a cold place to a warm place?
In this case, do not connect the plug to the power outlet and wait for two hours.
Then insert the disc and try to play back again. It will work properly when condensation has
evaporated.
Angle operation
does not work during
playback of a DVD disc.
Angle operation is available only when the disc contains images captured at different
angles.
The disc revolves, but
no image or bad quality
images are output.
• Check whether there is damage or foreign materials on your disc.
• Some discs with bad manufacturing quality may not be played back.
• If the scene changes from dark to bright suddenly, the screen may jitter temporarily, but it
is not defective.
Desired sound language
and subtitle language
are not played.
Sound languages and subtitle languages are disc-specifi c.
Only the sound and subtitle languages contained on a DVD disc are available and
displayed on the disc menu.
No progressive output.
• Check whether PS
is displayed on front panel.
• Make sure to change the component video output using the Progressive button when the
disc is stopped.
The remote control
doesn't work.
• Point the remote control at the remote control sensor on your DVD Recorder & VCR.
Operate within distance. (15ft)
Remove obstacles between your DVD Recorder & VCR and remote control.
• Check whether the batteries are depleted.
Other problems
• Read the table of contents and then fi nd and read the sections describing your problem,
and follow the directions given.
• Turn the unit off and on.
• If your problem still persists, contact your nearest Samsung service center.
No HDMI output.
• Check that the Video output is HDMI enabled.
• Check the connection between the TV and the HDMI jack of the DVD Recorder &VCR.
• See if your TV supports this 480p/720p/1080i DVD Recorder &VCR.
Abnormal HDMI output
screen.
• If snow noise appears on the screen,it means that the TV does not support HDCP
(High-bandwidth Digital Content Protection).
HDMI output Jitter
• Check if your TV system is setup correctly.
• Screen Jitter may occur when the frame rate is converted from 50Hz to 60Hz for
720p/1080i HDMI (High Defi nition Multimedia Interface)Output.
• Please refer to the user ’s manual of your TV.
01343A-VR355-XAC-ENG.indb 8401343A-VR355-XAC-ENG.indb 84 2007-03-23 오후 6:52:392007-03-23 오후 6:52:39