Filter
Top Products
User’s Manual
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 07/10
118
5.8.1 Load Factory Default
This item is used to load the factory default setting. Select <Yes> to recall the
factory default setup configuration from the “read-only” memory, or select
<No> to cancel.
5.8.2 Import Configuration
This item allows the user to load a unit configuration that was saved on an
external drive. To import a configuration that was previously exported, make
sure the device that saved the configuration is connected to the unit. Select
<Import Config> from the Configuration menu and press ENTER. The
following menu is displayed.
Import Config
Config Name
xxxx-xxxx
xxx-xx
Select
No
No
Press UP / DOWN to select one of the available listed configuration files, and
choose <Yes> to start importing.
NOTE: If the imported configuration has a different record mode from
the unit’s, the warning message “This config has different record mode.
This will FORMAT ALL HARDDISKS.” will show.
NOTE: Remove the ThumbDrive
®
used for importing
configuration after the unit restarts, or it will be formatted as well.
5.8.3 Export Configuration
The account with appropriate privilege can save a unit configuration by
exporting it to an external drive, such as a USB Flash Drive. Before exporting
the configuration, make sure the device in which the configuration will be
saved is attached to the unit properly. Select <Export Config> from the
Configuration menu and press ENTER. The following menu is displayed.
Items in this menu are described in the following sections.
Export Config
Copy Destination
Config Name
Begin Export
No