Filter
Top Products
English - 18
INSTALLATION
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a
cable TV system (according to the instructions on pages 14~17).
• Please be sure to match the color coded input terminals and cable jacks.
1
Connect a coaxial cable between the “ANT 1 IN
(AIR)” (or “ANT 2 IN (CABLE)”) terminal on the TV and
the antenna out terminal on the VCR.
A coaxial cable is usually included with a VCR. (If
not, check your local electronics store).
2
Connect a set of audio cables between the “AV IN 1
(L, R)” jacks on the TV and AUDIO OUT jacks on the
VCR.
If you have a mono VCR, connect L (mono) to VCR
audio out using only one audio cable.
3
Connect a video cable between the “AV IN 1 (VIDEO)”
jack on the TV and the VIDEO OUT jack on the VCR.
Refer to your VCR’s instructions for more information
about how to view your VCR tape.
• Also, you can connect to “AV IN 2” on the side panel of TV.
TV Rear Panel
From Cable
Coaxial Cable
(Optional)
From Antenna
Video
Cable
(Optional)
Audio Cable
(Optional)
VCR Rear Panel
1
2
3
BP68-00545AEng 10/18/05 5:53 PM Page 18