Filter
Top Products
7-9
7-10
DIGITAL VIDEO RECORDER
(2) SYSTEM INFORMATION
The following illustration shows the initial settings of the SYSTEM INFORMATION menu.
It displays the basic system information.
If DISK END MODE in the RECORD MODE SETUP menu and the hard drive's capacity
(GB: Gigabyte) are set to OVERWRITE, you can tell from the information shown in the
CAPACITY(GB) and OVERWRITE(#) fields the number of times the hard drive has been
overwritten. The VERSION field shows the version of the software installed on the system
and the MAC ADDRESS field shows the MAC address entered in the system.
(3) SYSTEM STATUS
The following illustration shows the initial settings of the SYSTEM STATUS menu.
SYSTEM INFORMATION
HDD1
CAPACITY(GB) 80.00
OVERWRITE(#) 00000
VERSION SCR3000 V1.00
MAC ADDRESS 00-00-F0-XX-XX-XX
EXIT=[SEARCH]
SYSTEM STATUS
HDD SYSTEM OK
HDD REMAIN OVERWRITE
VCR SYSTEM OK
TAPE STATUS OK
TAPE REMAIN --:--
EXIT=[SEARCH]
1) HDD SYSTEM
This shows the status of the hard drive. Messages used to indicate hard drive status and their mean-
ings are as follows:
- OK : Normal
- HDD NOT IN : The hard drive rack is empty or the hard drive rack lock is unlocked.
2) HDD REMAIN
This shows the remaining hard drive space. However, if DISK END MODE in the RECORD
MODE SETUP menu is set to OVERWRITE, "OVERWRITE" will be displayed. The percentage of
remaining space will be displayed only if DISK END MODE is set to STOP.
3) VCR SYSTEM
This shows the status of the VCR. If the VCR fails, the CHECK LED will blink and the buzzer will
sound. Messages used to indicate VCR status and their meanings are as follows:
- OK : Normal
- DE : Drum Motor Emergency
- CE : Capstan Motor Emergency
- LE : Loading Motor Emergency
4) TAPE STATUS
This shows the status of the video tape. If the current status of TAPE STATUS is not normal, the
CHECK LED blinks and the BUZZER will sound at the interval of 1 second or continuously.
Messages used to indicate tape status and their meanings are as follows:
- OK : Normal
- REC PROTECT: When the it hasinserted tape has theremoved of REC SAFETY TAB removed.
- TAPE NOT IN: When the VIDEO TAPE is not inserted.
- TAPE END: When the VIDEO TAPE reaches the end part.
- TAPE PRE-END: When the remaining time of VIDEO TAPE is less than 5 minutes.
5) TAPE REMAIN
This shows the amount of physical tape capacity remaining.