Samsung Series 6 650 CRT Television User Manual


  Open as PDF
of 196
 
English - 10
Installing Batteries in the Remote Control
1 Lift the cover at the back of the remote control upward as shown in the figure.
2 Install two AAA size batteries.
➢
● Make sure to match the “+” and “–” ends of the batteries with the diagram inside the compartment.
● Do not mix battery types, i.e. alkaline and manganese.
3 Close the cover as shown in the figure.
➢
Remove the batteries and store them in a cool and dry place if you won’t be using the remote
control for a long time. The remote control can be used up to about 23 feet from the TV. (Assuming
typical TV usage, the batteries last for about one year.)
➢
Using the remote control with the On/Off( ) light button set to On will reduce the battery usage
time.
➢
If the remote control doesn’t work! Check the following
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power cut, or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?
Connections
Connecting VHF and UHF Antennas
Ifyourantennahasasetofleadsthatlooklikethis,see“Antennaswith300ΩFlatTwin
Leads” below.
Ifyourantennahasoneleadthatlookslikethis,see“Antennaswith75ΩRoundLeads”.
If you have two antennas, see “Separate VHF and UHF Antennas”.
Antennaswith300ΩFlatTwinLeads
Ifyouareusinganoff-airantenna(suchasaroofantennaor“rabbitears”)thathas300Ωtwinflatleads,followthe
directions below.
1 Place the wires from the twin leads under the screws on a 300-75 Ω adapter (not supplied).
Use a screwdriver to tighten the screws.
2 Plug the adaptor into the ANT IN terminal on the side of the TV.
Antennaswith75ΩRoundLeads
1 Plug the antenna lead into the ANT IN terminal on the side of the TV.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before
connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics
shops).
1 Connect both antenna leads to the combiner.
2 Plug the combiner into the ANT IN terminal on the bottom of the side panel.
BP68-00660A-00Eng_1.indd 10 2008-02-11 오후 8:38:31
 previous next