Filter
Top Products
3.2 Initializing a HDD
The SVS-5R shows the status of the RAID operation and connected SATA hard drives through
an LCD on the front panel.
Should connected SATA drive fail, the front LCD indicates the degraded status of the SVS-5R.
In this case, you can rebuild the RAID array by replacing the failed SATA hard drive.
- Using the enclosed access panel lock, open the right front panel, and then press the power
switch on the front panel for at least 2 seconds to turn on the SVS-5R.
Power Switch
- When the SVS-5R turns on, the front LCD displays a message as shown below. The SVS-5R
is initially set up to “RAID5 4d.” To use 4 SATA hard drives for RAID5, please wait for 20
seconds after turning it on. To use a different RAID mode, please refer to 4-1.RAID Settings.
※Caution: The SVS-5R is initially set up to “RAID5 4d”.