Filter
Top Products
- A confirmation message appears asking you if you really want to reset the RAID settings.
Resetting the RAID settings will delete ALL data saved in the SVS-5R. When the following
window appears, press the left button to reset the RAID settings.
- When the RAID5+Hotstandby mode is successfully configured, the LCD displays the following
message. Connect to a DVR to begin saving data.
4.2 RAID Rebuilding
4.2.1 RAID0
In the RAID0 mode, ALL data saved in the SVS-5R is lost if only ONE of the connected SATA
hard drives fails.
- During the RAID0 mode when one of connected SATA hard drives fails, the front LCD of the
SVS-5R displays the following message notifying you of the loss of ALL data.
SVS-5R R5 3d
d:OOOS
-- HALTED --
Bad Disk Count
RAID5 3d+HS
<-Init? Cancel->
※Caution: RAID0 does not offer the rebuilding option; you must replace a failed hard drive
and reinitialize a RAID mode.
Warning!!!
Data can be lost
When the SVS-5R is in the RAID rebuilding process and its connected DVR is in the Half
D1 or D1 mode, activating the playback option may cause skipping frames. This skipping
frame issue is simply caused by the RAID rebuilding process; once it is complete, the
screen will no longer skip frames and no data is damaged.