Filter
Top Products
4.2.5 RAID5+Hotstandby
During the RAID5+Hotstandby mode, when a SATA hard drive fails, another hard drive in
standby replaces the failed drive and rebuilds the RAID array. When replacing the failed SATA
hard drive, the new hard drive is automatically set to standby status.
- During the RAID5+Hotstandby mode, when a SATA hard drive fails, the SVS-5R activates
beeping sounds and the RAID error LED. To disable the beeping sounds, open the front panel
using the access panel lock, and then press the front mute switch. Check the front LCD to
make sure that the standby SATA hard drive has replaced the failed drive and begun
rebuilding the RAID array automatically. d:FOOR indicates both the failed SATA hard drive
and rebuilding one as well as the time to remaining rebuild the RAID array.
- When the failed SATA hard drive is replaced with a new one, the LCD displays the following
message. To put the new hard drive on standby, press the left button.
- The new hard drive is in standby mode while the RAID is being rebuilt.
-
When the RAID array is successfully rebuilt, the front LCD displays the following message.
SVS-5R R5 3d
d:SOOO
Rebuild d:SOOR
1h:31m
RAID rebuilding?
<-Okay?
Rebuild d:FOOR
1h:31m
SVS-5R R5 3d
d:OOOS