Filter
Top Products
《22》
PTZ Mode
(7) TRACE
■ This menu is for inputting camera movements, through joystick or camera control buttons, into the memory for a
certain period of time, to allow repeating of stored movements when performing the Trace (PATTERN) function.
Setting the TRACE SETUP menu by controller is only available for an SPD series.
In case of products by other manufacturers, the setting has to be done by the OSD menu of the camera.
See the camera manual for more information.
(7-1) TRACE Memory
① At the [PTZ SETUP 1 ▶] menu, press the ▶▶ button (see p.15).
② Press the 2 button to move to the Trace Setup screen.
③ Press the 1 button.
④ Use the joystick or camera control buttons to perform the camera
movement to input. Allowed movements are horizontal movements
(pan), vertical movements (tilt), zoom, and focus controls.
⑤ Press the ENTER button to stop camera movement input.
▤ Maximum length for movement memory is approximately 60 ~ 105
seconds. This may vary according to free memory space.
▤ Movement memory length may be shorter if the camera movement
is more complicated.
▤ Press the FUNCTION button and the 2 button to start TRACE
memory.Press the FUNCTION button and the 3 button to stop
TRACE memory. For more information, see p. 8.
PTZSETUP2
1:MODEL 2:TRACE
3:AF
PressNumericKey
PressNumericKey
PTZTRACESETUP
1:RECORD
2:PLAY
RECSTOP:PRESSENTER
PTZTRACERECORDING
PressNumericKey
PTZTRACESETUP
1:RECORD
2:PLAYONCE3:DELETE
(7-2) TRACE Operation
① At the Trace Setup screen, press the 2 button.