Filter
Top Products
178
There is something wrong
with the TV.
Try this!
Broadcasting is grayed
out.
The Broadcasting menu is only available when Source is set to TV.
The Broadcasting menu cannot be accessed while watching TV using a cable
box or satellite receiver.
The settings are lost
after 30 minutes or every
time the TV is turned off.
If Use Mode is set to Store Demo, the TV's audio and video settings are
automatically reset every 30 minutes.
Change Use Mode (Support > Use Mode) to Home Use.
There is an intermittent
loss of audio or video.
Check the cable connections and reconnect them.
Loss of audio or video can be caused by using overly rigid or thick cables.
Make sure the cables are flexible enough for long term use. If you are mounting
the TV to a wall, we recommend using cables with 90-degree connectors.
There are small particles
on the TV's bezel.
This is part of the product’s design and is not a defect.
The PIP menu is not
available.
PIP functionality is only available when you are using an HDMI or Component
source.
A POP (TV’s internal
banner ad) appears on
the screen.
Change Use Mode (Support > Use Mode) to Home Use.
The TV is making a
popping noise.
The expansion and contraction of the TV's outer casing may cause a popping
noise. This does not indicate a product malfunction. The TV is safe to use.
The TV is making a
humming noise.
Your TV utilizes high-speed switching circuits and high levels of electrical
current, and depending on the brightness level being used may seem slightly
noisier than a conventional TV.
Your TV has undergone strict quality control procedures that meet our
demanding performance and reliability requirements.
Some noise coming from the TV is considered normal and is not an acceptable
cause for an exchange or refund.
Image Retention (Burn
In) Issue
This issue affects PDP TVs only. Watching TV for an extended period of time or
using the 4:3 screen ratio only may result in burn-ins.
PDP TVs are equipped with Pixel Shift screen burn reduction technology. Pixel
Shift technology reduces screen burn-ins in PDP TVs.
It does this by moving the picture slightly vertically or horizontally.
Use Screen Burn Protection (System > Screen Burn Protection) to prevent
screen burn-ins.