Filter
Top Products
English
- 9
To receive television programmes a signal
must be received from one of the following
sources:
• An outdoor aerial
• An indoor aerial
• A cable television network
• A satellite receiver
1 Remove the aerial or network input cable
from the television.
2 Connect this cable to the 75Ω coaxial jack
marked on the rear of your DVD-VCR.
3 Plug the RF Cable supplied into the jack
on your DVD-VCR.
4 Plug the other end of the RF Cable into the
connector previously used for the aerial on
the television.
TV
You can connect your DVD-VCR to the tele-
vision using the Audio/Video cable if the
appropriate input is available on the televi-
sion. You thus:
• Obtain better quality sound and pictures
• Simplify the setting up procedure of your
DVD-VCR
1 Connect the RF Cable.
2 Connect one end of the Audio/Video cable
to the Video output and Audio L, R output
jack on the rear of the DVD-VCR.
3 Plug the other end into the appropriate
connector on the television.
ANT IN
Aerial
Aerial cable
RF cable
• Make sure that both the television and the
DVD-VCR are switched off before connecting
the cables.
Note
Connecting DVD-VCR to the TV
using the Audio/Video Cable
Connecting DVD-VCR to the TV
using the RF Cable
TV
RF cable
Aerial cable
Aerial
2
3
4
• Regardless of the type of connection chosen,
you must always connect the RF Cable sup-
plied. Otherwise, no picture will be visible on
the screen when the DVD-VCR is switched off.
• Make sure that both the television and the
DVD-VCR are switched off before connecting
the cables.
Notes
C
C
onnections
onnections
Yellow
6700_XSA_Eng1(01) 2/14/07 7:54 PM Page 9