Sanyo DSR-M DVR User Manual


 
14 English
OPERATION
3 NORMAL RECORDING/TIMER RECORDING
Follow the steps below to record the monitored image.
1 Set the TV SYSTEM selector switch on
the rear panel to PAL.
Switch TV SYSTEM based on the camera and monitor to
be connected.
2 Press the [REC/STOP] button.
The REC indicator lights.“z” (the recording symbol)
appears on the screen, and recording starts.
z When you record for the first time, the initial settings are
used. To change the image quality, see P.29.
z When the remaining space for recording reaches zero,
recording ends and the FULL indicator lights. You can
start recording from the beginning again by changing
the “OVER WRITE” recording setting. (JP.29)
z You can record and play back images at the same time.
See P.16 for the procedure.
3 Press the [REC/STOP] button for about
3 seconds.
The REC indicator goes out and recording stops.
Follow the steps to record the monitored image onto the
hard disk at the set time.
1
Press the [TIMER] button.
The TIMER indicator lights, and the digital video recorder
enters timer recording standby mode.
z
A warning tone sounds if timer recording hasn’t been set.
(1) See P.31 for how to set timer.
(2) When the time specified in the timer settings arrives,
the REC indicator lights, “z” (the recording symbol)
appears in the screen, and recording starts.
(3) When the set end time arrives, the REC indicator goes
out, and recording stops.
(4) The following restrictions apply to normal recording
and timer recording.
z After making “PICTURE QUALITY” or “AUDIO
RECORDING” menu settings and returning to the
camera screen, recording does not start for a
maximum of 6 seconds (although normal recording
and timer recording operations can be made).
z After recording finishes (the REC/STOP indicator
turns off), recording does not start for a maximum of
10 seconds (although normal recording and timer
recording operations can be made).
z When the remaining memory space for recording
reaches zero, recording ends, and the FULL indicator
lights. You can start recording from the beginning again
by changing the “OVER WRITE” setting. (JP.29)
z You can record and play back images at the same time.
See P.16 for the procedure.
1
Press the [TIMER] button.
The TIMER indicator goes out and recording ends.
[REC/STOP] button
TIMER indicator
[TIMER] button
FULL indicator
REC indicator
Normal recording
Ending normal recording
HI A 120H
20-05-04 AL 00015
08:30:35 ----------
Recording symbol
HI A 120H
20-05-04 AL 00015
08:30:35 ----------
Timer recording
Stopping during timer recording
HI A 120H
20-05-04 AL 00015
08:30:35 ----------
Recording symbol
HI A 120H
20-05-04 AL 00015
08:30:35 ----------
e00_l8hae_xe_7.book Page 14 Monday, July 5, 2004 10:02 AM