Filter
Top Products
SETTING THE CASSETTE EJECT MODE
Cassette Eject Setup
When using 2 VCRs or more, the cassette tape of all the
VCRs or some of the VCRs can be ejected, if the EJECT
terminals on the VCRs are connected as indicated.
1 Press the MENU button until the (SET UP 2) menu is
displayed.
2 Press the ] button, until the “EJECT MODE” setting
is flashing.
3 Press the l (or j) button to set the desired cassette
eject mode.
EJECT1 . . . . . . . . . . The cassette is ejected only
if the VCR is not in recording
mode.
EJECT2 . . . . . . . . . . The cassette is ejected only
if the VCR is in stop mode.
4 Press the PAUSE/SEARCH button, the normal
screen is displayed.
°
The setting procedure is now completed.
EJECT terminal connection
EJECT IN terminal
•
Depending on the (SET UP 2) menu “EJECT
MODE” setting (see “Cassette Eject Setup”), the
cassette loaded in the VCR is ejected when there is
an input at this terminal.
EJECT OUT terminal
•
When the EJECT button is pressed or when there
is an input (trigger) at the EJECT IN terminal, a
signal is output at this terminal, even if the security
lock is set or if a cassette is not loaded.
<SET UP 2>
¤DISPLAY
DATE Y
TIME Y
ALARM COUNT Y
¤TAPE IN MODE STOP
¤TAPE END MODE REW
¤TAPE END OUT -3M
¤SERIES REC N
¤EJECT MODE EJECT 1
¤THREAD CHECK Y
VCR No. 1
EJECT
OUT IN
VCR No. 2
EJECT
OUT IN
COM
COM
NU4Q/U (SRC-800 GB) Fri. Aug., 06/1999
19