Sanyo SRC-850 VCR User Manual


 
SETTING THE CASSETTE EJECT MODE
Cassette Eject Setup
When using 2 VCRs or more, the cassette tape of all the
VCRs or some of the VCRs can be ejected, if the EJECT
terminals on the VCRs are connected as indicated.
1 Press the MENU button until the (SET UP 2) menu is
displayed.
@@@@@@@<SET@UP@2>
öDISPLAY
@@@DATE@@@@@@@@@@Y
@@@TIME@@@@@@@@@@Y
@@@ALARM@COUNT@@@Y
öTAPE@IN@MODE@@@@STOP
öTAPE@END@MODE@@@REW
öOUTPUT@@@@@@@@@@SERIES
öSERIES@REC@IN@@@N
öEJECT@MODE@@@@@@EJECT1
öTHREAD@CHECK@@@@Y
2 Press the ] button, until the “EJECT MODE” setting
is flashing.
3 Press the l (or j) button to set the desired cassette
eject mode.
EJECT1 . . . . . The cassette is ejected only if the
VCR is not in recording mode.
EJECT2 . . . . . The cassette is ejected only if the
VCR is in stop mode.
4 Press the PAUSE/SEARCH button to save the
setting.
NOTE:
The EJECT button will not be operative during
recording mode.
EJECT terminal connection
EJECT IN terminal
Depending on the (SET UP 2) menu “EJECT
MODE” setting (see “Cassette Eject Setup”), the
cassette loaded in the VCR is ejected when there is
an input at this terminal.
EJECT OUT terminal
When the EJECT button is pressed or when there
is an input (trigger) at the EJECT IN terminal, a
signal is output at this terminal, even if the security
lock is set or if a cassette is not loaded.
VCR No. 1
EJECT
OUT IN
VCR No. 2
EJECT
OUT IN
COM
COM
NU4Q/U3 (SRC-850 GB) Mon. Aug., 23/1999
English
23