Sanyo SRC-850 VCR User Manual


 
OUTPUT TERMINALS
TAPE END OUT Terminal
During recording, when the end of the tape is reached
or when the tape counter reading indicates 7 hours 57
minutes or more, the output becomes 0V (Low).
To reset the output, press the STOP or EJECT button.
During autorepeat recording, when the end of the tape
is reached, the output becomes 0V (Low) for about 2
seconds only.
TAPE END OUT Terminal Output Setting
1 Press the MENU button until the (SET UP 5) menu is
displayed.
@@@@@@@<SET@UP@5>
öTAPE@END@OUT@@@@-3M
öWARN.@OUT@@@@@TRANSPORT
öRS485
@ADDRESS@@@@@@@@@000
@TERMINATE@@@@@@@N
@DATA@SPEED@@@@@@19200
@STATUS@INFO@@@@@Y
@ALARM@INFO@@@@@@Y
2 Press the l (or j) button, to select the desired output
mode.
–3M . . . . . . . . The output becomes 0 V (Low)
and the TAPE END indicator
flashes when the tape counter
reaches “7:57:00” and/or when
the tape reaches the end.
END . . . . . . . . The output becomes 0 V (Low)
and the TAPE END indicator
flashes when the tape reaches
the end.
4 Press the PAUSE/SEARCH button to save the
setting.
COM Terminal
Common GND (ground) terminal when connecting
other terminals to external devices.
WARNING OUT Terminal
If the tape stops or other problem, the output becomes
0V (Low).
To reset the output, press the STOP or ALL RESET
button or unplug the power cord then plug it back in.
WARNING OUT Terminal Output Setting
NOTE:
If in the (SET UP 4) menu “VIDEO LOSS” is set to “N”,
the “WARN. OUT” setting will be preset to
“TRANSPORT” and cannot be changed.
1 Press the MENU button until the (SET UP 5) menu is
displayed.
2 Press the ] button, until the “WARN. OUT” setting is
flashing.
3 Press the l (or j) button, to select the desired output
mode.
TRANSPORT . The output becomes 0V (Low)
when the tape stops or other
probrem with the internal
mechanism.
V. LOSS . . . . . The output becomes 0V (Low)
when there is no video signal
(Please refer to page 13, “Action
to Take when the Video Signal
Deteriorates.”).
T OR V . . . . . . The output become 0V (Low)
when the tape stops or other
problem with the internal
mechanism, or when there is no
video signal (Please refer to page
13, “Action to Take when the
Video Signal Deteriorates.”).
4 Press the PAUSE/SEARCH button to save the
setting.
Tape end or 7:57:00
5V (H)
0V (L)
(Output impedance: 5.7 k)
Output reset
Tape movement stop
5V (H)
0V (L)
(Output impedance: 5.7 k)
Output reset
NU4Q/U3 (SRC-850 GB) Mon. Aug., 23/1999
26
English