Filter
Top Products
53
■
LC-80LE857U/LC-80LE757U/LC-80LE657U/LC-80LE650U/LC-80C6500U
The wall mount kit (sold separately) allows you to mount the LCD Monitor on the wall.
For detailed information on installing the wall mount, see the instructions provided with the product.
We recommend you to contact a technician for assistance when installing it.
SHARP is not responsible for any damage to the product or injury to yourself or others if you elect to install
the wall mount on your own.
CAUTION
• Install your wall mount on a solid wall perpendicular to the fl oor.
When you want to attach the wall mount to surfaces other than plaster board, please contact your
nearest retailer/adviser for additional information. If you install the LCD Monitor on a ceiling or slanted
wall, it may fall and result in severe personal injury. Always have two people mount the LCD Monitor on a
wall.
Wall Mount Kit Specifi cations
Standard dimensions for wall mount kits are shown below.
• The illustration is based on the LC-80LE857U model as an example.
A
b1
B
b3
c1
b2
a2
a1
WALL MOUNT KIT
WALL MOUNT KIT
WALL
VESA screw hole specs (A-B) 23
5
/
8
(600) – 15
3
/
4
(400)
Width
a1: Maximum distance from the mounting hole 2
61
/
64
(75)
a2: Maximum distance from the Monitor's center 14
49
/
64
(375)
Height
b1: Distance between the Monitor's center and the mounting hole 7
3
/
4
(200)
b2: Maximum distance from the Monitor's center 13
19
/
32
(345)
b3: Maximum distance from the mounting hole 5
23
/
32
(145)
c1: Minimum gap 3
5
/
32
(80)
Appendix
DEPTH OF
MOUNTING HOLES
SCREW
WALL MOUNT
UNIT
MOUNTING
HOLES
CABINET
For the screws, refer to the table shown below.
Standard screws M8 (Use 1.25 pitch screws.)
Length(Depth of mounting holes)
31
/
64
(12)
Quantity 4 pcs.
NOTE
• Do not mount the LCD Monitor at a tilt.
• Due to the terminal confi guration on this LCD Monitor, when you wall-mount this model, make sure there is
enough space between the wall and the LCD Monitor for the cables.
• To use this LCD Monitor mounted on a wall, remove the cable tie as needed.
• Do not use screws that do not comply with the VESA standard screw specifi cations.
• Do not use screws that are longer than the standard length. Screws that are too long may cause damage to
the inside of the LCD Monitor.
• Do not fasten the screws too fi rmly or loosely. This may damage the product or cause the product to fall,
leading to personal injury. SHARP is not liable for these kinds of accidents.
• SHARP is not liable for product damage or personal injury when a non-VESA or non-specifi ed wall mount is
used or the consumer fails to follow the product installation instructions.
Do not install the wall mount kit while your LCD Monitor is turned on. It may result in personal
injury due to electric shock.