Sharp XG - NV6XU Projection Television User Manual


 
E-14
Setup & Connections
2. Connecting the Projector Continued
Connecting an amplifier and other audio
components
CAUTION
Always turn off the projector while connecting to audio
components, in order to protect both the projector and the
components being connected.
By using external audio components, the volume can be amplified for
better sound.
To audio input terminals
Audio cable (sold separately)
Connecting RS-232C Port
When the RS-232C port on the projector is connected to a computer with an RS-232C cable (cross type, sold
separately), the computer can be used to control the projector and check the status of the projector. See pages 52
and 53 for details.
DIN-D-sub RS-232C
cable
QCNW-5288CEZZ
Computer audio cable
QCNW-4870CEZZ
Computer cable
QCNW-5304CEZZ
Computer cable
Computer audio cable
(3.5 mm stereo minijack cable)
DIN-D-sub RS-232C cable
CAUTION
Do not connect or remove RS-232C cable to or from the computer while it is on. This may damage your computer.
The wireless mouse or RS-232C function may not operate if your computer port is not correctly set up. Please refer to the operation manual
of the computer for details on setting up/installing the correct mouse driver.
The arrows (, ) indicate the direction of the signals.
A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Authorized Sharp Industrial LCD
Products Dealer or Service Center.
RS-232C cable
(cross type, sold separately)
Amplifier