Filter
Top Products
E26
Digital connection
Connect the separately-sold digital signal cable
(model name: NL-C04J) to the digital RGB output
terminal of the computer.
See page E10 for information on removing/
replacing the terminal cover.
- The TV has an input terminal for connecting to a
computer with a DVI-compatible output terminal
(DVI-D 24 pin or DVI-I 29 pin).
(Depending on the type of computer to be
connected, the display may not work correctly.)
- Paying attention to the connector direction, firmly
insert the signal cable straight into the
connector, and then tighten the screws at both
ends.
Connecting the TV to a computer
Notes:
- Make sure that the connected computer is
switched off.
- After making the connection, follow the
procedure below.
1. Press the POWER button to turn on the TV.
(See page E32.)
2. Press the PC button once or twice to select
PC (digital) mode. (See page E32.)
After a short time, the message asking you to
change the "DVI SELECT" setting might
appear. When the message appears, go to
step 3.
3. Press the button to select "PC".
The computer will be selected as the
connected equipment and the message will
disappear.
4. Turn on the computer.
- If the message described in step 2 appears
during the operation, follow the instructions in
the message for the proper setting and then turn
off/on the power to the connected computer.
- If the image does not appear properly, turn off
power to the connected computer. Again, set
"DVI SELECT" to "PC" following steps 1 through
4 above.
Connecting the audio cable
Connect the supplied PC audio cable to the audio
output terminal of the computer.
See page E10 for information on removing/
replacing the terminal cover.
DVI input terminal
(DVI-D 24 pin)
Digital signal cable
(separately-sold)
Digital RGB
output terminal
PC audio input terminal
Audio
output
terminal
PC audio cable
(supplied)
Computer
Computer
LD-26SH1U_gb_01.P65 2005/01/21, 13:5126