Filter
Top Products
Using the Remote Control (RM-Y806)
7
If the component does NOT respond
Try programming the remote using the other codes listed for your
brand. If you still cannot get your component to respond after trying
all the codes, your component may not be compatible with this
remote. If this happens, you must use your component’s remote to
operate it. Or, as an alternative, you can use the following
instructions to program the Digital Network Receiver’s remote to
control the volume level.
Programming the
Remote to Control
Volume Level
If you cannot successfully program the Digital Network Receiver’s
remote to control your TV (as described on page 6), you can still use
this remote to control the volume level (and
MUTE
) that is output from
the Digital Network Receiver’s audio
LINE OUT 1 (TV)
and
TO TV/VCR
jacks.
To program the remote to control the volume level
1
Press the
CODE SET
button.
2
Enter
200
using the 0-9 buttons.
3
Press the
#
button (located below the “
9
” button).
To check if the code works
1
Aim the remote control at the Digital Network Receiver.
2
Press the
VOL+, VOL-,
or
MUTE
button. If the volume level responds,
you’re done.
If you replace the TV or purchase a new one
Try programming the remote control as described on page 6, or you
can continue to control only the volume level as described in this
section.
Replacing Batteries
in the Remote
When the batteries need to be replaced, insert two size AA batteries
by matching the + and
–
on the batteries to the diagram inside the
battery compartment.Then replace the battery compartment lid.
✍
Remove the batteries to avoid damage from possible battery leakage whenever you
anticipate that the remote control will not be used for an extended period.
Handle the remote control with care. Avoid dropping it, getting it wet, or placing it in
direct sunlight, near a heater, or where the humidity is high.
CV.book Page 7 Thursday, November 30, 2000 2:13 PM