Filter
Top Products
Connecting the Digital Network Receiver
17
TV and VCR with RF Connectors Only
1
Connect the coaxial cable from the wall outlet (Cablevision cable
network signal) to the Digital Network Receiver’s
CABLE IN
jack.
2
Connect the Digital Network Receiver’s
TO TV/VCR
jack to the
VCR’s
VHF/UHF IN
(or
RF IN
) jack.
3
Connect the VCR’s
VHF/UHF OUT
(or
RF OUT
) jack to the TV’s
VHF/UHF IN
(or
RF IN
) jack.
4
Connect one end of the AC power cord to the Digital Network
Receiver’s
AC IN
jack, then connect the plug end to an AC outlet.
5
Set your VCR’s channel switch (usually on the rear panel) to
channel 3.
AC cord
TV
VCR
Coaxial cable
From wall
outlet
4
213
CV.book Page 17 Thursday, November 30, 2000 2:13 PM