Filter
Top Products
25
Getting Started
Getting Started
Setting up the G-CODE system for satellite
broadcasts (if applicable)
When your satellite tuner is connected via the AERIAL IN connector, first
you have to set the programme position for each satellite channel using the
TUNER PRESET menu. Then set the guide channel number for each satellite
channel using the SET UP CH AND G-CODE menu.
If your satellite tuner is connected via the LINE-1 IN jacks, you do not have
to set programme positions nor guide channel numbers for satellite
channels. Skip the following operations.
1 Turn on the satellite tuner.
2 Press MENU, then select TUNER PRESET and press OK.
3 (For SLV-EZ66AZ only)
Press M/m/</, to select AUS or NZ, depending on the country you
live in.
4 Press PROG +/– to select a programme position you want to use for
watching a satellite channel.
5 Select CHANNEL SET, then press / to tune
the VCR to the satellite tuner.
The channel number displayed beside
CHANNEL SET is used for receiving all
satellite broadcasts from the satellite tuner.
6 Press PROG +/– to select another programme position for another
satellite channel, and press the programme number buttons to enter the
same channel number as the one displayed in step 5.
Repeat this step for all satellite channels.
7 Set the guide channel number for each programme position assigned to
the satellite channel, following the procedures in “Setting up the
G-CODE system manually” on page 23.
Notes
• The menu disappears automatically if you do not proceed for more than a few
minutes.
• If you inadvertently entered a guide channel number, press >/. repeatedly to reset
the “GUIDE CH” column to “---”. “---” appears between 1 and 255.
• The VCR does not allow entering the guide channel number, if the same number
has been set.
• If you use a satellite tuner connected via the LINE-1 IN jacks, you do not have to set
up the G-CODE guide channels. Just record a satellite programme using the
G-CODE number, and the VCR automatically records the programme from the
LINE-1 IN jacks.
• When you record a satellite broadcast using the G-CODE number, you need to
select the desired channel on the satellite tuner manually.
e.g. SLV-EZ77AS
SELECT
SET
:
[]
:
[
]
PROG 6
TUNER PRESET
NORMAL / CATV
AUTO PRESET
CHANNEL SET
AFT
ADD / ERASE
FINE TUNING
NORM
ON
•
•
CATV
OFF
ADD• ERASE
30