Filter
Top Products
7
Getting Started
Getting Started
Manufacturer
Sony 01*
1
,02
Akai 68
Blaupunkt 10
Ferguson 52
Grundig 11*
1
Hitachi 24
ITT/Nokia 15,16,69*
3
JVC 33*
Loewe 45
Mivar 09, 70
NEC 66
Panasonic 17*
1
,49
Manufacturer
Philips 06*
1
,07*
1
,08*
1
Saba 12,13
Samsung 22,23
Sanyo 25
Sharp 29
Telefunken 36
Thomson 43*
2
Toshiba 38
Code number
Code number
Notes
• The TV/VIDEO button selects an input source of the TV from either aerial in or line
in. The button does not control this VCR.
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not use different types of batteries.
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer’s code
number.
1 Set TV / VIDEO at the top of the remote commander to TV .
2 Hold down ?/1, and enter your TV’s code number(s) using the
programme number buttons. Then release ?/1.
Now you can use the ?/1, VOL +/–, PROG +/–, programme number
buttons, ? (ten’s digit) and TV/VIDEO buttons to control your TV. You
can also use the buttons marked with a dot (•) to control a Sony TV. To
control the VCR, reset TV / VIDEO to VIDEO .
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
continued