Filter
Top Products
ICD-SX57 GB 2-894-353-52 (1)
61
GB
Using the IC Recorder with Your Computer
Note
If you wish to move the software to
another drive or directory after it is
installed, you need to uninstall the
software and then reinstall it. The
software does not work properly if you
just move the les.
Tips
You can also start up the uninstaller by
clicking [Start] and then selecting [Settings],
[Control Panel], and [Add/Remove Programs].
Uninstallation does not remove the message
files.
Connecting the IC Recorder
to your Computer
You can transfer the IC recorder data
onto your computer by connecting the
IC recorder to the computer.
Use the USB connecting cable supplied
with the IC recorder to connect the USB
connectors of the IC recorder and your
computer.
The IC recorder is recognized by
the computer as soon as the cable
is connected. You can connect or
disconnect the cable when the IC
recorder and the computer are turned
on or o.
USB connecting cable
(supplied)
To USB jack
To USB connector
of your computer
Notes
Be sure to install the Digital Voice Editor
software before connecting the IC recorder
to your computer. Otherwise, a message like
[Found New Hardware Wizard] may appear
when you connect the IC recorder to your
computer. In this case, click [Cancel].
Do not connect more than two USB devices
to your computer. Normal operation will not
be guaranteed.
Use of this IC recorder with a USB hub or a
USB extension cable is not guaranteed.
A malfunction may occur depending on the
USB devices connected at any one time.
Before connecting the IC recorder to the
computer, check that batteries are inserted
in the IC recorder.