Filter
Top Products
ICD-SX57 GB 2-894-353-52 (1)
71
GB
Troubleshooting
Symptom Remedy
The IC recorder or
“Memory Stick” cannot be
properly connected.
Check that the installation of the software has been successful.
Also check the connection as follows:
When using an external USB hub, connect the IC recorder directly
to the computer.
Disconnect and then connect the cable with the IC recorder.
Connect the IC recorder to another USB connector.
Your computer may be in the system standby/hibernate mode.
Do not let your computer enter into the system standby/
hibernate mode while being connected to the IC recorder.
The IC recorder does not
operate.
You may format the memory of the IC recorder. Use the IC
recorder formatting function to format the memory.
Messages cannot be
played back./Playback
sound volume is too low.
No sound board is installed.
No speaker is built-in or connected to the computer.
The volume of the sound is turned down.
Turn up the volume on the computer. (Refer to the instruction
manual of the computer.)
The volume of WAV les can be changed and saved using the
“Increase Volume” feature of the Microsoft Sound Recorder.
Saved message les
cannot be played back or
edited.
You cannot play back a message whose le format the Digital
Voice Editor software does not support. Depending on the
le format, you cannot use part of editorial features of the
software.
Counter or slider moves
incorrectly.
There is noise.
This happens when you play back messages that you divided,
combined, overwrote, or added a recording. Save a message in
the hard disk rst, and then add it to the IC recorder. Select the
saving le format that suits the IC recorder you use.
Operation is slow when
there are many messages.
When the total number of messages increases, the operation
becomes slower, regardless of the length of the recording time.