Filter
Top Products
26
Executing a Series of Commands
— System Control Function
(continued)
Tips for programming the
System Control function
The following information helps
you to program a consecutive
operation steps.
About the interval between
operation steps
You can change the interval between
operation steps (see page 29).
About the order of operation
steps
•Some of the components may not
accept consecutive remote control
signals. For example, a TV generally
does not react to a next signal right
after the Power-on signal. So, a series
of commands such as TV Power-on
and input select may not work
properly. In this case, insert other
signals like the example below;
TV Power-on t VCR Power-on
t VCR play back t TV input select
•By programming an often-used
component’s command as the final
step, you can save the step of
pressing a Component Select button
when you start operating that
component.
To clear programmed
commands
While holding S (set)
pressed, press one of the
SYSTEM CONTROL 1, 2, or
3 button.
All Component Select buttons
light up when you press these
buttons, and turn off when you
release them.
To set the SYSTEM CONTROL 1
or 3 button back to the factory
setting
At the factory, the SYSTEM
CONTROL 1 button is preset with
the System Power-Off function for
Sony components, and the
SYSTEM CONTROL 3 button is
factory preset with standard
power-on command for nearly all
Sony components. To reset them
to the factory settings, clear the
“learned” commands on the
SYSTEM CONTROL 1 or 3 button.
The System Control functions will
be restored.