Filter
Top Products
38
Transferring Data
between Remote
Commanders
You can transfer the data, such as
“learned” signals and component
code settings, between this
Commander and another Sony
RM-VL900 or a Sony RM-AV2100
remote commander.
If you want to exchange data
with a Sony RM-AV2100
Refer to “Data Transfer”
instructions in the RM-AV2000
manual for the necessary
procedures.
Note on remote commanders
You can transfer data between remote
commanders with the
mark. Other
remote controls cannot be used to
transfer data.
Transferring the data
You can transfer all data of this
Commander or the data of a
Component Select button on this
Commander to another Sony
RM-VL900 or RM-AV2100.
To transfer all data of the
Commander
1 Place the RM-VL900 head
to head with another
remote commander.
Another remote
commander
RM-VL900
about 2 – 4 inches
(5 – 10 cm) away
2 Press and hold S (set) for
more than 3 seconds.
The S (set) indicator lights up,
and all Component Select
buttons flash.
3 While holding cursor v
pressed, press the Number
1 button.
The S (set) indicator flashes
and all Component Select
buttons light up.