Filter
Top Products
40
5 Press ENT (Start data
transfer).
After the data is transferred,
the Component Select button
turns off.
If data transfer has been
unsuccessful during or after
procedure, the S (set) indicator
and the selected Component
button flashes five times, and
the Commander returns to its
state in Step 3. Either try again
from Step 5, or press S (set) to
cancel data transfer.
Notes
•The data of the “learned” signal and
the System Control function
programmed on a Component Select
button cannot be transferred.
You can use the Learning function
(page 15) to program the “learned”
signal and the System Control
function programmed on a
Component Select button on another
remote commander.
•Be sure that the receiving remote
commander is ready to receive data.
Receiving the data
This Commander can receive the
data of another Sony RM-VL900 or
RM-AV2100.
To receive the all data from
another remote commander
1 Place the RM-VL900 head
to head with another
remote commander.
2 Press and hold S (set) for
more than 3 seconds.
The S (set) indicator lights up,
and all Component Select
buttons flash.
Another remote
commander
RM-VL900
about 2 – 4 inches
(5 – 10 cm) away
Transferring Data between
Remote Commanders
(continued)