Filter
Top Products
42
Transferring Data between
Remote Commanders
(continued)
To receive the data of the
Component Select button from
another remote commander
1~2 Perform Steps 1 to 2 on
page 40.
3 While holding cursor V
pressed, press the
Component Select button to
which want to set the data.
The S (set) indicator flashes,
and the selected Component
button lights up.
4 Confirm that the sending
remote commander is ready
for data transfer.
(To set the sending
commander, follow the
procedure on page 39.)
Note
Be sure that the sending remote
commander is ready to transfer
data.
5 Press ENT.
The S (set) indicator lights up
and the selected Component
button turns off (data-reception
standby).
6 Press ENT (ENTER) on the
sending remote
Commander.
After the data is received, the
Component Select button lights
up. If data transfer has been
unsuccessful during or after
the procedure, both the S (set)
indicator and the Component
button flash five times, and the
Commander returns to its state
in Step 5. Either try again from
Step 6, or press S (set) to cancel
data receival.
Note
If you do not perform Step 6 within 10
seconds, the S (set) indicator and the
Component Select button flash five
times, followed by a short pause, and
then flash again.