Filter
Top Products
Antenna Grounding According to the NEC
Relcr to section 54-300 of Panadiml Electrical Pode lor Antenna
Grounding.
t<g <___
Antenna lead-in wire
Ground clam/_
i_ _ _ _//" Antenna lead-in wire
| Elect_rica_ -- _u- / (NEC Section 810-20)
| service
| equipment .... ,_. Grounding conductors
..... •_[_//_ (NEC section 810-21)
_ Ground clamps
--,-.s,--..__ _ Power service grounding
NEC: National electrode system (NEC Art
Electrical Code 280 Part H)
Cleaning
[_ Cleafl the r_ar cover al_a of rhe TV regularly. Dust in the rear cover
mea may cause a problem with the cooling system of tile TV set.
[] Clean lhe cabinel ol tile TV with a dry soft
F0
cloth. To relnove dust lboln the screen, wipe il N _ _v'_l
gently witl/a sofi clotll. Stubborn slai..........y be_'_J I I _._
relnoved with a cloth slightly daml)ened with _v:2211::::5_ tl I
sollllion of lnild soap alld warm water. Ne_, er
use strong solvents such as thinner or benzine lor cleaning. If the
picture becomes (lark aller using the TV lor a king period of time. il
may be necessary lo clean tile inside of the TV. Consull qualified
service personnel.
[] Unplug tile AC power cord when cleaning tills unil. Cleaning Ibis
unil wilh a plugged AC power cord may result in electric shock.
On Contamination on the Screen Surface
Tile screen surl, Lcchas a special coaling to reduce reflections. To prcvenl
screen damage, clean tile screen as lhllows:
[] Clean tile screen with a soft clotll.
[] To remove hard contamination, use a clolh moislened wilh a
solution of mild delergenl and water. [)4)not spray cleaning solution
directly onto the TV. It should only be sprayed 1omoislen llle
cleaning clolh.
[] Do not use any type of abrasive pad, alkaline cleaner, acid cleaner,
scouring powder, chemical cloth, or solvent such as alcohol,
benzene or thinner, ;isthese lnay scralc]l the screen's coating.
Service
Damage Requiring Service
Do not altelnpl to servicersthe set b)'')otu_ll since"opening_ I_
tile cabinel may ex Ioe y4u tl danger_ i1_ '4Itage 4r 4ther _/_ ,_ _,
hazards. I_ _
Unl)lug the set h'oln lhe wall outlet and relier servicing to [_
qualified selvice personnel.
Replacement Parts
_'tlell replacement parts are requilwl, be SUlVthe set, ice technician
cerlifies in writing lhal he has used replacement paris specified by the
ii/anul_lcnlr_2rlhal have lhe same characterislics as tile original parts.
Unauthorized substitutions may result illfire, eleclric shock or other
hazards.
See "Replacing the Laml)" on page 76.
For Safety
Be Careful When Moving the
TV
When you place tile TV in position, be carelul
IIOI tO drop it on yo/ir Loot or Lingers.
Watch your looling while inslalling lhe TV.
Carry the TV in the Specified
Manner
II you carry tile TV in a lnanner other than tile
specilied rammer and withoul tilespecified number
4)1persons, il may drop anda serious injury may be
caused. Be sure to lolh)w tile instructions
mentioned below.
[] Carry tile TV wilh lhe specified number of persons (see page 13).
[] Hold tile TV tigla/y when canting it.
[] Belhre carlTing the TV, disconnect any accessories or cables.
About the TV
Although lhe TV is made with high-precision lechnology, black dots may
appear or bright poinls ol light (red. blue, or green) may appear conslantly
on tile screen. This is a Stlucmral property ol tile panel and is not a detect.
Installation ,,
E] It'direct sunli=ht or other strong illmnination shines on tile screen,
par t of the screen may appear white due to reflections/?vm behin d
the screen. This is a structural property of the TV.
Do not expose the screen to direct illumination or direct sunlight,
[] Tile picture quality may be allbctcd by your viewing position. For
file best picture quality, install your TV according n)
"Recomnlended Viewing Area" on page 15.
[] When installing your TV against a wall, keep it at least 4 inches ( 10
cm) away lrom tile wall.
Projection Lamp
[] Your TV uses a projection lamp as its ligla source. II is time to
replace tile lamp wilh a new one (nol supplied) when:
• tile message, "Pl'_iection lamp is nearing end of lili:. Please
replace tile ]amp?'appeared on tile screen,
• lhe lamp replacenlent indicator on lbe lronl panel blinks in red.
• screen ilnages becolne dark,
• no image appears on tile display aller prolonged u_e.
[] In rare insnmces, tile bulb may pop inside the lamp unit, but the lamp
unil is designed lo contain all of broken glass piecesinside lbe lamp
unit. (See "Replacing the Lamp" on page 76 0
E] When the lamp eventually burns out, you may hear anoticeable pop
sound. This is normal and is inhm_nt in this type of lamp.
Cooling Fan
This TV u_s a cooling l,m. You may hear tile noise of l,m running,
depending on tile placclnent 4)1your TV. Tile noise may be nlore noticeable
during tile nigla or when tile background noise level is low.
Disposal of Used Batteries
To prowl're our enx,'ironll/ent, dispose o| used biU_elies accordhlg to your
local laws or regulations.
6