Filter
Top Products
46
Specifications
• Optional accessories availability depends on its stock.
• Design and specifications are subject to change without notice.
Model KDL-32LL150
System
Television system NTSC: American TV standard
ATSC (8VSB terrestrial): ATSC compliant 8VSB
QAM on cable: ANSI/SCTE 07 2000 (Does not include CableCARD functionality)
Channel coverage Analog terrestrial: 2 - 69 / Digital terrestrial: 2 - 69
Analog Cable: 1 - 135 / Digital Cable: 1 - 135
Panel system LCD (Liquid Crystal Display) Panel
Speaker output 10 W + 10 W
Input/Output jacks
CABLE/ANTENNA 75-ohm external terminal for RF inputs
VIDEO IN 1/2 S VIDEO (4-pin mini DIN) (VIDEO 2 only): Y: 1.0 Vp-p, 75 ohms unbalanced, sync negative /
C: 0.286 Vp-p (Burst signal), 75 ohms
VIDEO: 1 Vp-p, 75 ohms unbalanced, sync negative
AUDIO: 500 mVrms (Typical) / Impedance: 47 kilohms
COMPONENT IN 1/2 YP
BPR (Component Video): Y: 1.0 Vp-p, 75 ohms unbalanced, sync negative / PB: 0.7 Vp-p, 75 ohms
P
R: 0.7 Vp-p, 75 ohms / Signal format: 480i, 480p, 720p, 1080i, 1080p
AUDIO: 500 mVrms (Typical) / Impedance: 47 kilohms
HDMI IN 1/2/3
HDMI: Video: 480i, 480p, 720p, 1080i, 1080p, 1080/24p
Audio: Two channel linear PCM 32, 44.1 and 48 kHz, 16, 20 and 24bits, Dolby Digital
AUDIO (HDMI IN 1 only): 500 mVrms (Typical) / Impedance: 47 kilohms
PC Input (see page 39)
AUDIO OUT 500 mVrms (typical)
DIGITAL AUDIO OUT
(OPTICAL)
PCM/Dolby Digital optical signal
PC IN D-sub 15-pin, analog RGB, 0.7 Vp-p, 75 ohms, positive
See the PC Input Signal Reference Chart for PC and HDMI IN 1/2/3 on page 39.
PC AUDIO INPUT Stereo mini jack, 500 mVrms, (Typical) / Impedance: 47 kilohms
USB Hi-Speed USB
Power and others
Power requirement 120-240 V AC, 50/60 Hz
Power consumption
135 W
in use
in standby Less than 0.5 W
Screen size
(inches measured diagonally)
31.5
(32 class)
Display resolution 1,366 dots (horizontal) × 768 lines (vertical)
Speaker/Full range (2) (mm)
(inches)
34 × 160
1
3
/8 × 6
1
/3
Dimensions with stand (mm)
(inches)
801 × 554 × 222
31
5
/8
× 21
7
/8
× 8
3
/4
without stand (mm)
(inches)
801 × 505 × 94
31
5
/8
× 19
7
/8
× 3
3
/4
wall-mount hole pattern (mm)
200 × 200
wall-mount screw size (mm)
M6
(length: refer to diagram on page 40)
Mass with stand (kg)
(lb.)
12.7
28.0
without stand (kg)
(lb.)
11.4
25.3
Supplied accessories
Remote control RM-YD028 (1) / Size AA batteries (2) / Operating Instructions (1) / Quick Setup Guide
(1) / Warranty Card (1) / Safety and Regulatory Booklet (1) / Attaching the Table-Top Stand (1) /
Screws (4)
Optional accessories Connecting cables / Support Belt Kit / Wall-Mount Bracket: see page 2