Filter
Top Products
Installing and Connecting the Projection TV
28
Model name1[KP-51WS500] Model name2[KP-57WS500] Model name3[KP-65WS500]
[4-088-847-11 (1)]
Connecting a Digital TV Receiver
Disconnect all power sources before making any connections.
1 Using three separate component video cables, connect the Digital TV
Set-top box’s Y, P
B and PR jacks to the projection TV.
2 Using an audio cable, connect the Digital TV Set-top box’s Audio OUT
jacks to the projection TV’s AUDIO IN jacks.
✍ The Y, PB and PR jacks do not provide audio, so audio cables must
be connected to provide sound.
✍ Component video connection is necessary to view 480p, 720p, and
1080i formats. You may also use the S VIDEO or Composite Video
connections, however, component video (Y, P
B, PR) will provide the
best picture quality for all format types.
Be sure to read the
Set-top box manual.
Some Digital TV
Receivers are equipped
with a DVI connection.
Refer to your Digital TV
Receiver manual for
setup instructions using
this connection.
z
z
VMC-10HG (not supplied)
Digital TV Set-top box
RK-74A (not supplied)
AUDIO-R (red)
AUDIO-L (white)
Rear of projection TV
PR
PB
Y
✍ You cannot record the signal from any equipment connected into the
Y, P
B and PR connectors.
✍ This projection TV is not compatible with digital TV receivers
configured with RGB or VGA output connectors.
✍ The DVI connection is compliant with the EIA-861 standard and is
not intended for use with personal computers.
01COV.book Page 28 Tuesday, April 2, 2002 12:22 PM