Filter
Top Products
— 23 —
KV-27S40 / 27S45 / 27S65 / 29SL40 / 29SL40A / 29SL40C/
29SL45 / 29SL65 / 29SL65C/ 29XL40M / 29XL40P / 29XT11A
2-4. PICTURE TUBE REMOVAL
Do not use sharp objects which may cause damage to the sur-
face of the anode-cap.
Do not squeeze the rubber covering too hard to avoid damag-
ing the anode-cap. A material fitting called a shatter-hook ter-
minal is built into the rubber.
Do not force turn the foot of the rubber cover. This may cause
the shatter-hook terminal to protrude and damage the rubber.
HOW TO HANDLE AN ANODE-CAP
Turn up one side of the rubber cap in
the direction indicated by arrow .
When one side of the rubber cap sepa-
rates from the anode button, the anode-
cap can be removed by turning the rub-
ber cap and pulling it in the direction of
arrow .
Use your thumb to pull the rubber cap
firmly in the direction indicated by
arrow .
REMOVAL OF THE ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
REMOVAL PROCEDURES
WARNING Before removing anode cap:
H.V. remains in the CRT even after the power is disconnected.
To avoid electrical shock, discharge CRT before attempting to remove the anode
cap : Short between anode and CRT coating earth ground strap.
Coating earth
ground strap
E board
Chassis assy
Cushion
Degaussing coil
Neck assy
Deflection yoke
Four screws
(Tapping screw 7)
Anode cap
C board
Picture tube
P board
Tension spring (B)
K board
(KV-27S65/29SL65/29SL65C ONLY)
(KV-27S45/27S65/29SL45/29SL65C/29SL65)